Some parts of the knitting machine, such as the spindle bracket, the sliding seat, etc., must be secured to the distance between the sliding seat and the lower ingot braiding wire after repairing and disassembling or replacing new parts. It is recommended to first place a carriage and the upper spindle to run on the sliding turntable so that the lower braided wire is not hooked or cut by the carriage when it is guided from the swinging rod to the weaving point.

When the knitting machine is coarsely adjusted, put the spindle on the two adjacent outer spindle supports, and guide the braided wire to the weaving point through the swinging rod, and press it tightly. When the braided wire enters or exits from the slot on the sliding carousel track, its distance to the edge of the upper carousel must be substantially equal. The adjustment of the distance can be achieved by changing the gear carrier forward or backward one or several gears.

In order to maintain the performance of the knitting machine, the equipment is inspected according to the standard, so that the abnormal state of the equipment can be found early, and establishing the inspection system for checking the latitude center is an important means for doing a good job of maintenance work. The so-called check is the inspection tour of the key parts of the equipment and the project. State maintenance is always outstanding, and for every day-to-day operation, every part of the equipment is inspected every day.